ViewSonic PRO8500 Guide de l'utilisateur télécharger pdf (Page 24)

ViewSonic Pro8500 22

Operation

Powering On/Off the Projector

Powering On the Projector:

1. Remove the projector lens cap.

2. Complete the AC power cord and peripheral signal cable(s) connections.

3. Press to turn on the projector.

The projector takes a minute or so to warm up.

4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically

detects your source.

 If you are connecting multiple sources to the projector simultaneously, press

SOURCE on the projector to select your desired signal or press your desired

signal key on the remote control.

Warning

 Remove the lens cap first before powering on.

 Never look into the lens when the lamp is on. This can damage your eyes.

 This focal point concentrates high temperature. Do not place any object near

it to avoid possible fire hazard.

Powering Off the Projector:

1. Press to turn off the projector lamp. You will see a message

"Power off?

Press Power again"

appear on the screen.

2. Press again to confirm.

 The cooling fans continue to operate for cooling cycle.



When the Power LED begins flashing, the projector has entered stand-by

mode.

 If you want to turn the projector back on, you must wait until the projector has

completed the cooling cycle and has entered stand-by mode. Once in stand-

by mode, simply press to restart the projector.

3. Disconnect the AC power cord from the electrical outlet and the projector.

4. Do not turn on the projector right after power off.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 73 74

Pas de commentaire

ViewSonic PRO8500 Guide de l'utilisateur Page 24