Viewsonic 300 Manuel d'utilisateur télécharger pdf (Page 18)

16 ViewSonic PJ750

No Signal Menu

The same adjustments and settings are available as with the Image and

Options menus when the MENU button is pressed during display of

the “NO INPUT IS DETECTED ON***”or “SYNC IS OUT OF

RANGE ON***”message while no signal is received. Select an item

with the and buttons, and start or stop the operation with the

and buttons.

Table 8: No Signal Menu

Item Description

VOLUME

Reduce Increase

• When this function is used, audio input is automatically switched to video. The

audio input can be switched by moving the DISK PAD left and right during the

display of the volume adjustment bar. The volume adjustment bar is displayed by

pressing VOLUME button.

BLANK

Select Blank Screen Color:

Select the color with the button.

• When the blank mode is set with BLANK ON, without a signal, or with a non-

standard signal, the image is cleared and the complete screen is displayed in the

selected color.

MIRROR

Select Mirror Status:

Select the mirror status with the button.

START UP

Setup Initial Screen Display:

Select the TURN ON with the button.

Clear Initial Screen Display:

Select the TURN OFF with the button.

• Note that if TURN OFF is selected the blank screen is displayed in blue when

there is no signal.

MENU COLOR

Select Menu Background Color:

Select the color with the buttons.

LANGUAGE

Select Menu Display Language:

Select the language with the buttons.

AUTO OFF

Set AUTO OFF:

Set 1-99 minutes with the buttons. The system

automatically enters the standby mode when a signal is not detected for the set

time.

Clear AUTO OFF:

Select the STOP (0 min.) with the button. When the STOP

is selected the system does not enter the standby mode even if no signal is

received.

SYNC ON G

SYNC ON G Valid:

Select the TURN ON with the button.

SYNC ON G Invalid:

Select the TURN OFF with the button.

• May not be displayed correctly with some input signals when the SYNC ON G is

valid. In such cases, remove the signal connector so that no signal is received,

set the SYNC ON G to invalid, and reconnect the signal.

WHISPER

Set / Clear WHISPER Mode:

Press the button. When WHISPER is

selected, the WHISPER mode is active. In the WHISPER mode, acoustic noise

level from the unit is reduced, and brightness level on the screen is a little lower.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Viewsonic 300 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Viewsonic 300