ViewSonic VE710s-4 Guide de l'utilisateur télécharger pdf (Page 9)

Using the LCD Display

Setting the Timing Mode

Setting the timing mode is important for maximizing the quality of the

screen image and minimizing eye strain. The timing mode consists of the

resolution (example 1024 x 768) and refresh rate (or vertical frequency;

example 60 Hz). After setting the timing mode, use the OnView

controls

to adjust the screen image.

For the best picture quality set your LCD dislay timing mode to:

VESA 1280 x 1024 @ 60 Hz.

To set the Timing Mode:

Set the resolution: Right-click on the Windows desktop > Properties >

Settings > set the resolution.

Set the refresh rate: See your graphic card's user guide for instructions.

WARNING:

Do not set the graphics card in your computer to exceed the

maximum refresh rate of 75Hz; doing so may result in permanent damage to

your LCD dislay.

OSD and Power Button Lock Modes

OSD Lock This mode locks all current control settings and prevents access to

the control menus until this mode is unlocked.

• OSD Lock: Press and hold [1] and the up arrow

for 10 seconds. If any

buttons are pressed the message OSD Locked will display for 5 seconds.

• OSD Unlock: Press and hold [1] and the up arrow

again for 10 seconds.

Power Button Lock This mode locks the power of the LCD dislay in the ON

position.

• Power Button Lock: Press and hold [1] and the down arrow

J for 10

seconds. If the power button is pressed the message Power Button Locked

will display for 5 seconds. With or without this setting, after a power failure,

your LCD dislay’s power will automatically turn ON when power is restored.

• Power Button Unlock: Press and hold [1] and the down arrow

J again for

10 seconds.

ViewSonic VE710b_VE710s 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Pas de commentaire

ViewSonic VE710s-4 Guide de l'utilisateur Page 9