ViewSonic Pro10100 Guide de l'utilisateur télécharger pdf (Page 67)

Lamp Replacing Procedure:

1. Switch off the power to the projector by pressing the “ ” button.

2. Allow the projector to cool down for at least 30 minutes.

3. Disconnect the power cord.

4. Unscrew the two screws on the lamp door.

5. Open and pull up the lamp door.

6. Unscrew the three screws on the lamp housing.

7. Pull out the lamp module slowly and carefully.

To replace the lamp module, reverse the previous steps.

8. Turn on the projector and use “Lamp Reset” after the lamp module

is replaced.

Lamp Reset: (i) Press “Menu”  (ii) Select “OPTIONS”  (iii) Select

“Lamp Settings”  (iv) Select “Lamp Reset”  (v) Select “Yes”.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

Pas de commentaire

ViewSonic Pro10100 Guide de l'utilisateur Page 67