ViewSonic VS11446 Manuel de service télécharger pdf (Page 20)

ViewSonic Corporation Confidential - Do Not Copy VX2235wm-4

Crystal Frequency Output

RTD can output crystal frequency or 1/2 crystal frequency to external MCU to save a crystal device.

Once power state is on and reset is finished, we can set crystal frequency by firmware and output to pin

48 and pin 110 simultaneously, and then can turn off them in Pin Share Part. Pin 48 and PIN 110 is

configurable, detail setting is listed in Pin-Share part

RTD2120 8051 Embedded Micro-Controller for Monitor

Overview

This chip is the micro-processor of LCD monitor. It uses the design ware DW8051 of

Synopsys as the 8051 core of this chip and is compatible with other industry 8051 series. Also,

96Kbyte FLASH with 8 bit bus is embedded in this chip which is licensed from TSMC 0.18um

e-FLASH process. Here we use the package of PLCC44/LQFP48 if we would like to have a

discrete MCU controller or we make a multi-chip package with our LCD monitor controller to

form one chip package to save the cost of package and PCB material.

Features

　Operating voltage range : 3.0V to 3.6V

　8051 core, CPU operating frequency up to 50MHz

　4 clocks per machine cycle

　256-byte internal RAM

　512-byte external data RAM, including 256-byte DDC RAM(128-byte x 2) and 256-byte

general purpose RAM

　96K-byte flash memory, 64k for program and 32k for saving parameter

　Two DDC ports compliant with VESA DDC1/2B/2Bi/CI

　Three channels of PWM DAC with programable frequency from 100K to 100Hz

　Watchdog timer with programmable interval

　Three 16-bit counters/timers (T0, T1, and T2)

　One PLL to provide programmable operating frequency and clock output, 2 clock output ports

　One full-duplex serial port

　Six interrupt sources with 2 external interrupts

zFour channels of 6-bit ADC

zHardware In System Programming(ISP) capability, no boot code required

zBuilt-in Low voltage reset circuit

zEmbedded 1.8V regulator

zCode protection

zAvailable in 44-pin PLCC or 48-pin LQFP package

AUDIO STEREO CLASS-D AUDIO POWER AMPLIFIER

DESCRIPTION

The TPA2008D2 is a third generation 5-V class-D amplifier from Texas Instruments. Improvements to

previous generation devices include: dc volume con-trol, lower supply current, lower noise loor ,higher

efficiency, smaller packaging, and fewer external components. Most notably, a new filter-free class-D

modulation technique allows the TPA2008D2 to directly drive the speakers, without needing a low-pass

output filter consisting of two inductors and three capacitors per channel. Eliminating this output filter

saves approximately 30% in system cost and 75% in PCB area.

The improvements and functionality make this device ideal for LCD projectors, LCD on itors ,powered

speakers, and other applications that demand more battery life, reduced board space, and functionality

that surpasses currently available class-D devices.

A chip-level shutdown control limits total supply current to 1 µA, making the device ideal for bat-

Tery powered applications. Protection circuitry in-creases device reliability: thermal and short circuit.

Under voltage shutdown saves battery power for more essential devices when battery voltage drops to

low leve.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

ViewSonic VS11446 Manuel de service Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Téléviseurs et moniteurs ViewSonic VS11446