ViewSonic PJD6223 Guide de l'utilisateur télécharger pdf (Page 45)

Controlling the projector through a LAN

environment

This function is only available for the PJD6223/PJD6253/PJD6553w series.

The projector supports Crestron

software. With correct settings for the LAN Control

Settings menu, you can manage the projector from a computer using a web browser when

the computer and the projector are properly connected to the same local area network.

Configuring the LAN Control Settings

If you are in a DHCP environment:

1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector

and the other end to the RJ45 port.

2. Press MENU/EXIT on the projector or Menu on the remote control and then press

/ until the SYSTEM SETUP: Basic menu is highlighted.

3. Press to highlight LAN Control Settings and press MODE/ENTER on the

projector or Enter on the remote control. The LAN Control Settings page is

displayed.

4. Press to highlight DHCP and press / to select On.

5. Press to highlight Apply and press MODE/ENTER on the projector or Enter on

the remote control.

6. Please wait for around 15 - 20 seconds, and then re-enter the LAN Control Settings

page. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server

settings will be displayed. Note down the IP address displayed in the Projector IP

Address row.

• If the Projector IP Address still does not appear, contact your network administrator.

• If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask,

Default Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are

properly connected and perform the procedures above again.

• If you need to connect to the projector in its standby mode, set Power Saving to Off.

TYPE B

USB

LAN

RS-232

(An example of connection)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 87 88

Pas de commentaire

ViewSonic PJD6223 Guide de l'utilisateur Page 45