Viewsonic PJ510 Manuel d'utilisateur télécharger pdf (Page 16)

13 ViewSonic PJ510

Power ON/OFF

Turning On The Power

NOTE:

Turn the power on/off in right order. Please power on the projector before the connected devices.

Power off the projector after the connected devices.

1 Make sure that the power cord is firmly and correctly

connected to the projector and outlet.

2 When the lens cap is attached, remove the lens cap.

3 Set the power switch to [ | ] (ON).

Power switch (ON position)

The POWER indicator will light orange.

4 Press the STANDBY/ON button

of the projector or the remote control.

The projector lamp will light up and the POWER indicator

will begin blinking green.

According to a setup, the projector lamp may light up and

the POWER indicator may begin blinking green, without

pressing this button.

When the power is completely on, the indicator will stop

blinking and light green.

WARNING

When the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector.

STANDBY/ON button

POWER indicator

Power switch

STANDBY/ON button

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Pas de commentaire

Viewsonic PJ510 Manuel d'utilisateur Page 16