Viewsonic PJ510 Manuel d'utilisateur télécharger pdf (Page 30)

27 ViewSonic PJ510

AUTO Menu

With the AUTO menu, the items shown in the Table below can be performed.

Perform each operation in accordance with the instructions in the table below.

Item Description

ADJUST Automatically Adjust the Picture:

Pressing the (X) or the ENTER button performs this function

At a RGB input:

• V POSITION, H POSITION, H PHASE and HSIZE are automatically adjusted. Please use this

function with the maximum window size.

At a VIDEO input or S-VIDEO input:

• This function performs only when the AUTO is selected under the VIDEO item of the INPUT menu.

For a COMPONENT VIDEO input, although this function is ineffective, the signal type is identified

automatically even if the AUTO is not selected. For HDTV signals, refer to the HDTV item below.

• This function automatically selects the optimum mode for the input signal. However, it may not

work well at a PAL60 signal and some other signals. If the picture becomes unstable (ex. irregular

picture, color lack), please use the function of VIDEO of the INPUT menu.

• The operation of this function requires approximately 10 seconds.

POWER OFF Set the Automatically Power Off Timer:

Long (Max. 99 minutes.) (S) Q (T) Short (Min. 0 minute =DISABLE)

• This function performs only when the time is set to 1 to 99.

• When the set time passes without a valid signal (there is no signal, or the signal is out of

specifications), the projector lamp automatically goes off, and the POWER indicator begins

blinking. Please refer to the section “Turning OFF The Projector” of “Power ON/OFF” about the

turning off.

SEARCH Automatically Signal Search:

TURN ON (S) Q (T) TURN OFF

• If the TURN ON is selected under this item when no signal input is detected, the projector begins

searching for an input signal. When an input signal is detected the projector will cease searching

and the picture will appear.

• The priority of a search is as follows:

• If the projector is unstable to find an input signal at any of its ports, it will return to the state it was

in prior to the search.

RESET Reset the AUTO Menu Items:

Selecting the EXECUTE performs this function.

EXECUTE (S)  CANCEL

• The items of the AUTO menu are collectively returned to the initial setting. Note that the item

ADJUST is not reset.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

Pas de commentaire

Viewsonic PJ510 Manuel d'utilisateur Page 30