Viewsonic PJ510 Manuel d'utilisateur télécharger pdf (Page 23)

ViewSonic PJ510 20

Signal Searching

1 Press the SEARCH button

Cycles through input signals, displaying the images of retrieved signals. If no signal is found, it

returns to the signal that was selected before the search was initialized.

NOTE:

• May not function properly with some input signals.

• The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

1 Press the ASPECT button

RGB input

• At RGB input, selecting an aspect ratio may display the message “SYNC IS OUT OF

RANGE”. In this case, please select one of other aspect ratios.

VIDEO, S-VIDEO, COMPONENT VIDEO input

• At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i (1035i/1080i)/750p. only 16:9

can be selected.

• When the 4:3 is selected under the SCREEN TYPE item of the OPTION menu, WIDE and

ZOOM cannot be selected.

Temporarily Blanking The Screen

1 Press the BLANK button

The input signal screen is shut off, and a blank screen appears. You can set the blank screen using

the menu (from the SCREEN menu, select BLANK).

Press the BLANK button again to remove the blank screen, and return to

the input signal screen.

NOTE:

The temporary blank function will automatically finish if any button of the projectior is pressed, if

there is a change in the input signal's state and or if the following functions are pressed on the remote

control. (STANBY/ON, SEARCH, RGB, VIDEO, BLANK, AUTO, VOLUME, MUTE, POSITION

OR MENU button.)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 48 49

Pas de commentaire

Viewsonic PJ510 Manuel d'utilisateur Page 23