Viewsonic PJ510 Manuel d'utilisateur télécharger pdf (Page 40)

37 ViewSonic PJ510

Regarding The Indicator Lamps

Lighting and flashing of the POWER indicator, the LAMP indicator, and the TEMP indicator have

the meanings as described in the Table below. Please respond in accordance with the instructions

within the Table. If the same indication is displayed after the treatment, or if an indication other than

the following is displayed, please contact your dealer or service company.

ATTENTION

When the interior portion has become overheated, for safety purposes, the power source may be

automatically turned off, and the indicator lamps may also be turned off. In such a case, press the “

○” (OFF) side of the power switch, and wait at least 45 minutes. After the unit has sufficiently cooled

down, please make confirmation of the attachment state of the lamp and lamp cover, and then turn the

power on again.

POWER

indicator

LAMP

indicator

TEMP indi-

cator

Description

Lighting in

orange

Turned off

The unit is in a standby state. Please refer to the “Power ON/OFF” sec-

tion of this manual.

Flashing in

green

Turned off Turned off

The unit is warming up. Please wait.

Lighting in

green

Turned off Turned off

The unit is in an ON state. Ordinary operations may be performed.

Flashing in

orange

Turned off Turned off

The unit is cooling down. Please wait.

Blinking in

red

The unit is cooling down. A certain error has been detected. Wait until

the POWER indicator has finished flashing, and then perform the

proper response measure using the item descriptions below as refer-

ence.

Lighting or

blinking in

red

Lighting in

red

Turned off

The projector lamp has not been properly fixed (attached), the projec-

tor lamp does not light, and/or there is a possibility that the interior por-

tion has become heated. Turn the power OFF and wait at least 20

minutes. After the unit has sufficiently cooled down, please make con-

firmation of the following items, and then turn the power ON again. If

the same indication is displayed, please change the lamp.

• Is there blockage of the air passage aperture?

• Is the air filter is dirty?

• Does the peripheral temperature exceed 35°C?

Lighting or

blinking in

red

Blinking in

red

Turned off

The lamp cover has not been properly fixed (attached). Turn the power

OFF and wait at least 45 minutes. After the unit has sufficiently cooled

down, please make confirmation of the attachment state of the lamp

and lamp cover, and then turn the power ON again.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 48 49

Commentaires sur ces manuels

Pas de commentaire

Viewsonic PJ510 Manuel d'utilisateur Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Viewsonic PJ510